Category: everything
-
Meshtastic build
Right another post time lol Meshtastic build here we go parts list: 1) A raspberry pi (if you using the Linux native stuff otherwise any Lora enabled board https://meshtastic.org/docs/hardware/devices/ supported stuff listed here) I am using a pi 4 for my router build (also an sd card if you are using a pi and not…
-
ads-b receiver build
well been a while since I made a post or did anything with this site lolLately I’ve been down the plane tracking rabbithole as I mentioned in the last post and built a ads-b tracker system along with a few acars ones (https://airplanes.live and https://airframes.io) today I’m going to write about my setup and give…
-
Prusa Mini Filament Sensor Install
A few days ago I finally ordered the filament sensor for my prusa mini It came well packaged (got wet in the ran though hence no box..no fault of prusa or the delivery company) It uses an ir led and some printed parts (Mine came preassemabled as I bought it as a kit from the…
-
plane stuff
Been a while since I posted here so figured I’d make this post for a few reasons one to say I’m still around and other as a teaser with some build guides I might be planning Recently ish I’ve been working on ads-b and now acars stuff so if you haven’t already and are interested…
-
How to add a device to Zigbee2MQTT
Required: 1) Zigbee dongle of some kind (I have the sonoff one though the home assistant one is also good) sonoff dongle: https://amzn.to/3xjn4Dk (I got it from amazon years ago now though they have the same one on their site also which is an amazing dongle https://itead.cc/product/zigbee-3-0-usb-dongle/ref/304/ ) home assistant:2) some kid of machine running…
-
How to add wifi to the Prusa mini
needed: 1) esp01 or esp01s module amazon: https://amzn.to/3Hbtw0F (prusa also sells one https://prusa3d.com/product/wi-fi-adapter-esp-01s-for-mini-and-mk4/ )aliexpress: https://s.click.aliexpress.com/e/_DBYmhLR (affiliate link)2) 2.5mm allen key 3) prusa mini of course 4) pliers to get the power switch out possibly 5) usb stick (either the one supplied with the prusa mini or another one)6) computer step 1: Turn off the power…
-
Installing esphome on a nodemcu
parts needed: first you need to connect your esp board to your ha server (you can also use the https://web.esphome.io page) and get esphome flashed to the board, you may need to press the boot or en buttons if it gives an error about flashing for this guide I’m using a seperate programmer as I…